How To Program Clean Remote To Tv

Specifications & Instructions

INSTRUCTIONS FOR CR1R AND CR3BCB

Battery Installation:

1. To open cover: With keypad facing you, first slide dark lens encompass away from you lot (photo A, footstep i) and then lift lid upwards from the back (photo A, step ii)
2. When placing 2 AAA batteries in the compartment notation the + and - symbols on the metallic swivel should make contact with the corresponding + and - end of each bombardment (photo B).
3. Closing cover: With keypad facing away from you gently close encompass by pressing downward (photo C, stride 1) and sliding it toward the front end (keypad) until it is aligned. (photograph C, step ii)
4. Examination remote by pressing the power button; the LED should light indicating that the batteries are in correctly. If the LED doesn't light, and then the batteries are either in wrong or the batteries are bad.

Easy TV Setup

1. Plow on the TV and then stand dorsum most 5 feet from TV and Point the remote at the CENTER of the front end console of the Tv. It volition not exist necessary to bespeak the remote at that exact area in one case the remote is set up-upward.
2. Printing and firmly Hold downwards the Setup push, do not release. The LED will glimmer once and then after 7 seconds it will initiate lawmaking search. The LED volition keep to blink every 2 seconds. One time your Television set shuts off immediately remove your finger from the Setup button; the code automatically locks in.
3. Test the remote:
   • For Goggle box Only: Test Ability, Volume and Aqueduct Functions, if all work correctly setup is complete. If not, you may not have an exact code friction match. Start once again at footstep #one. The code search volition go along where it left off.
   • For TV Plus Cable Box: Simply test Ability and Volume function, Practice Not CHANGE CHANNELS. If these functions operate correctly See Cable Box Setup below.

Important Note: If you remember you lot missed the code or you lot intend to employ the remote on a different brand TV: See trouble shooting guide, whorl down.

Cablevision Box Setup

You must outset complete TV setup before proceeding.

1. With the cable box ON, Press and Hold Down both the SETUP and ENTER buttons at the same time,until the LED low-cal turns on and remains ON.

2. Enter the three digit straight admission number for your brand from the list beneath; the LED light will then turn off confirming it was accepted.

At present test the remote: Point the remote toward the Cable Box and Television receiver and try the CH+ and CH- buttons besides as the the channel numbers. If the channels change correctly, make sure VOL+ , VOL- and TV power (ON and OFF) piece of work. If they exercise, you are done. If non, repeat these steps with all the access numbers listed for your brand earlier trying the numbers listed every bit "Other".

Hint: If your Cable Provider is not listed, please search past the manufacturer of your cablevision box

Note: If your cable box has a power push, employ the CBL button on Clean Remote to power it on or off.

TROUBLESHOOTING INFORMATION

Important Note: If you think you missed the TV code or you intend to use the remote on a different brand Tv set: Reset the remote dorsum to the beginning of the lawmaking search: Press and hold the SETUP push down, and so press and hold the CC button down at the same time until the blood-red LED light blinks quickly three times, then release both buttons. You have at present reset the code listing back to the beginning. So see Like shooting fish in a barrel Television receiver Setup on folio 1.

Reset remote to work TV only without a cable box.

If you've already prepare the remote to work both a TV and a Cable Box and at present wish to operate Television set only without a cablevision box. Hold down the button and SETUP button together until the remote blinks 3 times quickly and immediately release both buttons. So follow the Reset pedagogy in the higher up paragraph

View PDF Version (Printable)

© 2022 Noso Command, LLC.

Source: https://cleanremote.com/specs_cr1r-hospitality

Share this post